transmission issue

[JNizzle918]

What's up guys alright I burned the clutch out of 90 ex so I replaced it and also replaced the master clutch cylinder and slave cylinder the transmission shifted great for a day and then the next day it didn't want to go in to ant gear I'm wondering if anybody may know what it may be your help is appreciated

[Jarrett]

Do you have a fluid leak anywhere in the hydraulic system? What is pedal feel like? Did you drain the transmission and forget to refill it? Did you put the linkages back on with cotter pins?

[xkjnboix]

bleed the system. if you didnt put trans fluid in it all of your teeth might be gone. no teeth no torque

[zodiak]

bleed the system. if you didnt put trans fluid in it all of your teeth might be gone. no teeth no torque

If this happens your gunna need a new tranny hope u put fluid in it

[JNizzle918]

All that was done by a mechanic. The pedal feels a little hard I don't believe I have a fluid leak because the clutch fluid container is full.

[drummersteve7]

any clicking upon engagement or disengagement?
does that clicking sound like it is coming from transmission?

[Granite CB7]

Make sure there is freeplay adj'd @ the clutch pedal, if not, the system will build up some serious pressure making the pedal effort alot more than it should be. Try bleeding it out again too.

[JNizzle918]

There isn't any clicking. I'm wondering why it worked one day and the next it didn't work.

[JNizzle918]

How do I bleed the system?

[zodiak]

Just like pumping brakes but instead pump clutch pedal then hold and loosen 10 mm bolt on slave cylinder and tighten it quickly just as you would do the brake bleed valve

[JNizzle918]

Thanks I appreciate it.