Double Din Radios.....

[91@CCORD74]

I have the Double Din Clarion touch screen radio, I have paper holding it in cas it keeps sliding out. My question is can I use the factory bracket that comes on the factory radio to install it? or will i have to order a double din bracket kit?

[JoshM]

or will i have to order a double din bracket kit?

That'll be your best option. It'll also look the cleanest.

[91@CCORD74]

That'll be your best option. It'll also look the cleanest.

got any you can recommend?, are the 5.99 ones on ebay worth it?

[wherm]

I would try going with a Metra kit. They are good quality.

[91@CCORD74]

I would try going with a Metra kit. They are good quality.

[Sarthos]

I have the cheap ebay one cause Best Buy doesn't carry double dins for the cb7 and I wasn't sure where else I could buy one locally (except an extremely expensive car audio place near me which charges up the ass for everything) the cheap ebay one kinda sucks, I had to hold it together with duct tape. But it works after that. The plastic clips wouldn't really hold on their own and the clips weren't right. One of the indents that a plastic tab went into was missing, one plastic tab was missing (the indent was just not cut out, there was no break, meaning the plastic tab was never there). So they're pretty cheap, but they work if you have a knife and duct tape.

[Hondateck2010]

I have the same issue and have it with paper on the sides for now. going to order a kit from this site I found. didn't order yet since I was upgrading and didn't want to break the kit taking in and out. here the site $20 shipped and its Metra !

http://www.sonicelectronix.com/item_...a+95-7801.html

[jova1993cb]

I got mine at Car Toys. It was 20 bucks but it fits perfect and gives it that facto look