If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I see you had to do some cutting...they wouldnt just bolt right in?
I found an 89 Legend Sedan SE and the leather is *MINT*. Upper back seat wont fit, as im sure the bottom wont either. Id like to save some time or effort, if necessary with this. If yours was a newer Legend, then I'll just have to plow a path and find out.
Wao sorry for the late reply, And I know I posted in your thread but just to clarify you do not need to cut anything. I will try and clean this thread up a bit with better pictures and showing how everything bolts up.
Well, i started pulling the seats out(89 Legend SE) and couldnt get to that rear, inside bolt and couldnt get it. I went ahead and measured and the Legend brack was quite a bit smaller than the Accord bracket. I wasnt able to check alignment, but like i said, if it wont/doesnt line up on all 4-bolts, then i honestly dont wanna risk it.
Well, i started pulling the seats out(89 Legend SE) and couldnt get to that rear, inside bolt and couldnt get it. I went ahead and measured and the Legend brack was quite a bit smaller than the Accord bracket. I wasnt able to check alignment, but like i said, if it wont/doesnt line up on all 4-bolts, then i honestly dont wanna risk it.
But i dont think it wouldve worked. I mean, im sure it could have, but...meh. Besides, i just could NOT get that 4th bolt out of either front seat. I was pissed.
The part that bolts into the floor of the car itself, would not work. The Legend had like 2 forward-facing bolts, 1 rear-facing and 1 side-facing.
The Accord has 2 forward-facing and 2 rear-facing.
Had i been able to get the Legend seats out, i wouldve been able to compare the bottoms. I mean, there has to be some way for it to work. I just wasnt able to find out this time.
Comment