long story short my car isnt boosting right now because the bolt that holds the waste actuator came loose and fell out so i was wondering if anybody knew what size bolt that is on the 14b that holds the actuator so i can fix it....thnx
Announcement
Collapse
Please DO NOT Post In The General Section
From this point on until otherwise briefed, posting in the general section of Performance Tech is prohibited. The only thing to remain here will be the stickies. We would just delete this section, but that would cause unintended results.
The majority of the threads created can appropriately be placed in one of the Performance Tech sub-forums or Technical; and the posting of them here is detrimental to the activity of said forums. If you have any questions about where you need to place your thread PM me or one of the other mods.
For the most part you all have caught on without this post, but there have been a few habitual offenders that forced me to say this.
Everyone will get a couple of warnings from here on out, after that I just start deleting threads.
Again if you have any questions, PM me or one of the other mods.
The majority of the threads created can appropriately be placed in one of the Performance Tech sub-forums or Technical; and the posting of them here is detrimental to the activity of said forums. If you have any questions about where you need to place your thread PM me or one of the other mods.
For the most part you all have caught on without this post, but there have been a few habitual offenders that forced me to say this.
Everyone will get a couple of warnings from here on out, after that I just start deleting threads.
Again if you have any questions, PM me or one of the other mods.
See more
See less
bolt size on 14b
Collapse
X
-
-
Originally posted by d112crzyget rid of your wg and use a carb spring.
I cant remember off the top of my head, But i'm sure it's a 10x1.25 thread?
Or is it imperial thread? lolLast edited by evil_demon_01; 03-25-2008, 07:41 AM.
Car Safety / General Servicing Checks --------Basic suspension checks
My 5.7 LS1 Holden Ute
A "Finished" project car is never finished until its been sold.
If at first you don't succeed, Try again. Don't give up too easily, persistance pays off in the end.
Comment
Comment