Announcement

Collapse

Please DO NOT Post In The General Section

From this point on until otherwise briefed, posting in the general section of Performance Tech is prohibited. The only thing to remain here will be the stickies. We would just delete this section, but that would cause unintended results.


The majority of the threads created can appropriately be placed in one of the Performance Tech sub-forums or Technical; and the posting of them here is detrimental to the activity of said forums. If you have any questions about where you need to place your thread PM me or one of the other mods.


For the most part you all have caught on without this post, but there have been a few habitual offenders that forced me to say this.


Everyone will get a couple of warnings from here on out, after that I just start deleting threads.

Again if you have any questions, PM me or one of the other mods.
See more
See less

what ratio??

Collapse
X
Collapse
 
  • Page of 1
  • Filter
  • Time
  • Show
Clear All
new posts
Previous template Next
    #1

    what ratio??

    what ratio on pistons should i run if i plan to build my bottom end. Im going to sleeve it, pistions, and rods. Im also going to p&p my head. Im going to use the DSM turbo stuff for my set-up. Any info on this would elp me alot. thanks
    Tags: None
    #2
    if ur boosting i'd only go as low as 8.5:1 but our stock 8.8:1 is fine also. Depends alot on if u want to keep the low end tq that u have. The lower the comp ratio the lower your tq will be b4 the turbo kicks in
    Knowledge is power...in EVERY sense of the word

    FSAE (F Series Accord Enthusiasts) ..."A dying breed thats taking it to the next level" #12

    Comment

      #3
      thanks alot guys. i'll let you know more as my project begins.

      Comment

      Previous template Next
      Working...
      X