Get it?
I found this tool that a company is selling:
http://www.quicktrickalignment.com/
And I'm staring at my screen thinking...wtf?? 400 bucks? For a level and some bars?
BS, So I'm going to try to make my own. I already ordered the exact same level used on their equipment. Fabricating some steel square shouldn't be to difficult and I should come out under $100. This thread will be my alignment tool build log.
My motivation for building this is because I'm tired of going to Firestone and them just adjusting my toe. Plus I'd like to be able to try out different geometry settings. I'm pretty good with triangles so it shouldn't be too difficult. If it comes together well, I'll throw it in the DIY section.
I found this tool that a company is selling:
http://www.quicktrickalignment.com/
And I'm staring at my screen thinking...wtf?? 400 bucks? For a level and some bars?
BS, So I'm going to try to make my own. I already ordered the exact same level used on their equipment. Fabricating some steel square shouldn't be to difficult and I should come out under $100. This thread will be my alignment tool build log.
My motivation for building this is because I'm tired of going to Firestone and them just adjusting my toe. Plus I'd like to be able to try out different geometry settings. I'm pretty good with triangles so it shouldn't be too difficult. If it comes together well, I'll throw it in the DIY section.
Comment