h22 swap

[david17]

ok i am finshing my h22 swap in my accord know i have a couple problems

1. i can not get my turn signals to work.
but hy hassereds do work.

2. my high bems dont work but my low beams do

3. i hit my horn and it worked but does not work eny more eny info would help

i cheacked all the fuses under the hood so far thanks joe

[Night Wolf]

1st did you change any thing on the turn light harness?
2nd try swapping the relay

[david17]

i did cut alot of the auto trans plugs maybe they are a ground i dont know enybuddy help me

[jdm_inspired]

Why did you cut the plugs? I didnt do that. Yours didnt come with a prelude harness? Well used to Accord harnesses anyway. Hmm...

[david17]

hmm i used the accord harness i also went from auto to 5 speed so i hade a lot of plugs left so i cut them

[david17]

no buddy ever had a problem with high beems or turn signals

[Night Wolf]

those A/T tranny plugs dont control the lights. I cut mines off too. I didnt have a problem. make sure you didnt brake a harness by the lights

[lucid]

Basically sounds like the light/switch problems should not be related to the swap. Check the fuses under the dash too. Did you mess with the switches recently? The wires for the lights don't go through the engine harness, I'm pretty sure. The most likely thing I can think of is maybe you damaged a relay for or a wire near the headlights while putting the engine assembly in.

The FSM and Haynes manuals will have systematic steps to check the electrical system.