Catalytic converter clearence

[Rayz92]

I need some input. My car is sitting pretty low and my catalytic converter has been taking a beating and finally crapped out on me yesterday
My current ride height is not what my sig shows I've raised it up a bit since the day i took that pic.
I there any way i can avoid going thru tons of catalytic converters without raising my ride height? and without deleting the catalytic I've done it once before and never again will i do it.

[Dobermann]

I'm about an inch lower than you are in that picture. I was dragging everwhere. When I made my exhaust I just shortened all the hangers and moved everything tighter to the car. I also ordered the flattest stuff I could find too.

[Rayz92]

Thanks dobermann. Hey wat kind of catalytic converter are you runnning if you don't mind me asking?

[Dobermann]

No problem

It came on the car. I doubt its stock, but its probably just an OE replacement. I'm not sure what one.

[Davids92Accord]

what suspension are you running is it bouncy? and what do you hit that it made you cat give out

[tommi]

make some kind of skid plate and weld it onto the cat and dp. only thing i can think of really.drive better? like mentioned. shorter hangers.

[Rayz92]

well i took my car to a muffler shop and i guess the welds just cracked so they fixed it and now it running fine i also got them to raise the whole exhaust up a tad bit.

And its not a bouncy ride so much, i think i just hit something while i was on the highway. i really don't know what tho because when i went on the tollway the car was fine and when i got off i felt the loss of power.
btw i have Koni yellow on Megan racing coil overs sleeves and cut bump stop a little more than half.

[Skeet Skeet]

You could probably run a spun cat and be ok.