ek hatch

[91cb7h22poss]

i know this is a bit off topic, but me and a friend swapped an obd1 motor into a obd2 car, everything is spliced in and ready to go, we also replaced the main relay, and checked basically everything on the car, any ideas, i know its vague, but its late, and we need help asap

[dj_ender]

i know this is a bit off topic, but me and a friend swapped an obd1 motor into a obd2 car, everything is spliced in and ready to go, we also replaced the main relay, and checked basically everything on the car, any ideas, i know its vague, but its late, and we need help asap

Well first off this belongs in " other automotive " and you didnt ask a single question, just babbled about an ek hatch that you swapped a motor into. Be clear or no one can help you out.

['93CB7Ex]

what ecu you running? also are yall using a jumper harness?

[91cb7h22poss]

stock 5 speed ecu, p75, obd2

[dj_ender]

stock 5 speed ecu, p75, obd2

Dude...whats your question? You still havent told us what you need help with.

[91cb7h22poss]

is there any input you can put in, thats my fucking question, i asked that the first time, i stated my facts, and i said any input? so if you have input tell me, if not than dont reply, im not tryna be a dick but damn dude

[dj_ender]

is there any input you can put in, thats my fucking question, i asked that the first time, i stated my facts, and i said any input? so if you have input tell me, if not than dont reply, im not tryna be a dick but damn dude

Im not either but you have not one time asked a question. What is your issue? What is the car doing/not doing? We dont know what you need help with. If your unclear re read your first post, theres no question. We will help once we know what you need help with.

[91cb7h22poss]

i said, my buddy put in a ls motor in a ek, we changed the main relay, still have not heard the three clicks, nor does the pump run, and when we turn it over, theres no spark, were completely lost at what is wrong, what could be wrong?

[dj_ender]

i said, my buddy put in a ls motor in a ek, we changed the main relay, still have not heard the three clicks, nor does the pump run, and when we turn it over, theres no spark, were completely lost at what is wrong, what could be wrong?

There you go, now we know specifically what you need help with. Have you checked all grounds and terminals for corrosion? Double checked the fuses? Is the car even turning over? Are you sure you have a good ECU? Did you make sure the ECU ground is hooked up at the T-stat? Or where ever it is for the B series.

[91cb7h22poss]

not sure on the ecu, we checked over basically everything, and yes the car is turning over, and we do not have any spark at the plugs when we turn it over

[dj_ender]

not sure on the ecu, we checked over basically everything, and yes the car is turning over, and we do not have any spark at the plugs when we turn it over

Open the ECU up and check for damage. Thats where I would start.

[91cb7h22poss]

and from there you would try what?

[dj_ender]

and from there you would try what?

Theres no spark at any of the cylinders? And did you replace with a new or used main relay? I would recheck everything very meticulously. Pretty easy to miss one plug or one ground on a swap. Maybe even the ignition control module could be a culprit.

[91cb7h22poss]

we did for sure check one of them, but im assuming from the rest of the circumstances none have spark, and the relay is out of a car we just drove home the other day, and it ran like a champ, we have yet to change the icm

[dj_ender]

we did for sure check one of them, but im assuming from the rest of the circumstances none have spark, and the relay is out of a car we just drove home the other day, and it ran like a champ, we have yet to change the icm

I know you said you checked everything, and with the main relay working I would tend to lean towards something not hooked up/grounded. Especially if all you did was swap an engine into a known working car. In that case the only thing you can really point to is the wiring harness. But if the car originally had issues then it opens up other avenues.