blinker/Flasher Relay Help needed!

[Gemini]

ahh hmm.. try replacing the hazard button. yours might be faulty. if you notice: unplugging the hazard button causes the signals to stop working entirely. maybe it just went out

even tho the hazards work?

edit: too think about it, I'm not sure but either the hazard or the rear defog button dont light up anymore. If its the hazards then it might be the culprit. I'll check tomorrow.

edit #2: Ok, just ran down to check and notice that the hazard button doesnt light up at all when I turn on the lights.

[accordaffair]

http://media.honda.co.uk/car/owner/m...400/16-183.pdf

Got a multimeter?

Also, this page was missing from the online stuff, clicked it from my book.

[Gemini]

http://media.honda.co.uk/car/owner/m...400/16-183.pdf

Got a multimeter?

No, but I think I can get one to borrow.

[Tatersplz]

Fuck Man, Am I The Only Guy That Ever Had This Problem?? Come On Guys, Someoen Help A Brother Out.

the same thing happened to me. and i drove around like that for about a week.then when i was heading to my local Hondapro (best mechanic i have ever used in my life) they worked. I do not know why they just worked. And have not stopped working since that day. I suppose it is because the cb knew it was going to the shop.

[cp[mike]]

Could just be the turn signal flasher. It is seperate from the hazard flashers. If you are getting solid green arrows on the dash the switch is more than likely good. Check the turn signal flasher before you spend money on a switch.

hes probably right, btw. try replacing the flasher relay, its separate from the hazard flasher relay. which would probably be why the hazards work but not the blinkers. its one of the relays above the under-dash fusebox. forget which one it is, but check a manual.

[Mike]

idk if anyone mentioned this i didn’t feel like reading all the posts

i haven’t seen it on an accord yet but somewhere in the dash there should be a 1 1/2 by 1 inch metal dome looking thing...this is the actual blinker- there’s a metal piece w/ current and it hits another metal piece completing the circuit (that’s how a blinker works and that’s where that ticking sound comes from)

theses go bad.....and there’s one for the blinkers and one for the hazards...which would explain why the hazards work

thats normaly the problem when blinkers stop working so check that out.
but like i said i havent needed to replace one on an accord yet so they may look different than what i descibed and it may not be in the dash

[cp[mike]]

^^ you just described a relay. and in this specific case, the blinker relay.

[Gemini]

Ok, thank you guys. I'm gonna borrow a multimeter and also grab a new hazard button and a flasher relay from the junkyard. I gotto wait till this weekend cause I'm working late all week.

[Tatersplz]

Ok, thank you guys. I'm gonna borrow a multimeter and also grab a new hazard button and a flasher relay from the junkyard. I gotto wait till this weekend cause I'm working late all week.

by the way, you have a baddass looking cb7. Good job sir.

[Gemini]

by the way, you have a baddass looking cb7. Good job sir.

Thank you bro, I appreciate it

[Gemini]

ok, I'm getting really frustrated now. I left work early to go to the junkyard so that I could grab a couple hazard buttons and flasher relays. Grabbed 4 hazards button and three flasher relays. I interchanged everyone of them in different orders and still no turn signal. I even interchanged the turn signal levers that I got a week or so ago but still no luck. I dont have a multimeter but I used my yellow fuse tester/puller than I had and 2 of the relays tested ok , the the hazard buttons tested good and 2 of the turn signal levers tested good. After identifying which ones are good I then interchanged and switched all the items around but still no luck. After spending all this time testing I realized that I left my $35 new era NY Yankee hat at the junkyard when i was taking out the relays from under the dash. Went back and it was gone I'm so fucking upset right now. I'm tempted to by new parts but donmt want to because what if thats not the problem

[accordaffair]

If all parts check out, the wiring is often suspect..

[HF22T]

there is actually a flasher and turnsignal relay under the hood not under the dash that i recal it may also be there unplug the battery let it sit for about 10 minutes then try again that may solve your pproblem the relay or something may have gotten over pulled and stuck due to current if not i can say that the circuits are partial to the cluster sure but that may help you sort things out

[Gemini]

there is actually a flasher and turnsignal relay under the hood not under the dash that i recal it may also be there unplug the battery let it sit for about 10 minutes then try again that may solve your pproblem the relay or something may have gotten over pulled and stuck due to current if not i can say that the circuits are partial to the cluster sure but that may help you sort things out

ok, I'll try this tomorrow or this weekend. I'm getting pretty good drving with signals tho...

[Gemini]

Finally got my turn signals fixed this weekend. Seems that i wasted my money buying a brand new switch and and relay...turns out that my fuse box under the dash has a sort of some king which stop my signals from working. I need to change this fuse box because it was the same thing that cause the issue with my windows being stuck and couldnt be put up...anyways I paid $14.99 for the check and $45 to fix which i thought was a little pricey for less tan 15 minutes work but i'm happy its fixed.