Air Fuel Ratio Gauge

[CB7Tuner915]

Ya i need some help hooking up a air fuel taio gauge what wires do i connect it too

Searched and couldent find a DIY

[DrLove'sKuDang]

well ive never done it, but i think you wire it to the o2 sensor

[CB7Tuner915]

Originally posted by DrLove'sKuDang
well ive never done it, but i think you wire it to the o2 sensor

well there is more than one wire comeing out of it. Where do i crimp into it or what

[h22sparkle]

its the wire closer to the o2 sensor on the harness closest to the cat. Its the white wire that gives it the signal then the power and ground and your all set. Remember the white wire.

[3rdworldakkord]

i currently ran mine to the white wire, would i need to Reset somthing because it Jumps So much compared to my friends who runs exactly with his RPMS

[ACCORDianate]

Did the gauge not come with instructions?

If not, contact the manufacturer for a set.

[fstacrd]

well if you replaced your oxygen sensor you'll have white wires and grey wires. but if you look at the stock wires before the plug, then you'll see a orange with a black stripe... that is the wire you would want to hook it too.

[plee3]

i currently ran mine to the white wire, would i need to Reset somthing because it Jumps So much compared to my friends who runs exactly with his RPMS

your friend must have a wideband A/F gauge. Any regular A/F gauge is going to piss you off because it jumps too much.