ENG: Setting the TPS Sensor

[Losiracer2]

and you make sure you have the key to II...

the only other possible thing would be if the ecu wasnt sending power to the sensor. i would check that at the plug.

like checking the yellow wire for 5v? I was thinking that since i've got an Auto H22, the Auto ECU might be diff. and thus causing the TPS not to read right?

[wed3k]

idk, im running an auto ecu with my manual and i dont have any problems. im not sure what my manual says about TPS diagnosis...brb

[wed3k]

Alright...disconnect 3p connector from TPS.

measure voltage between yellow/white terminal and green/white terminal. it should be 5v.

if there is not 5v...

measure voltage between yellow/white and ground. is there 5v?

if yes, repair open in green/white between ecu and TPS.
the rest of the procedures require a test harness that i guess only a honda technician has access to.

[lsn92ex]

i just got a 404 from the link...

[wed3k]

i just got a 404 from the link...

the link is actually on the end of the 2nd page.

[wed3k]

just did this again, so simple.

[Losiracer2]

just did this again, so simple.

damn i gotta do this, my multimeter sucks though, its one of those Autozone specials for 20 bucks. I need to buy the leads that just pinch the wire but doesn't remove any of the insulation.

[wed3k]

yea, again i just used a t tap and to make sur ei penetrated, i just check the resistance fromt he t-tap to the plug outlet.

mines an auto-zone special too. i setmine at .50 instead of .45 so ill have to change that tomorrow.

[gdout90accord]

back from the dead

i tried setting mine to .45v but the best i could do is .55v and thats the max i can turn the tps, anybody had this problem?

[wed3k]

make sure the tps is put in right.

[theSOB]

dead link

[wed3k]

http://www.nzintegra.com/settingtps.html

[theSOB]

thanks. i got a H22 TB, it was working fine on and H23, do i need to adjust the TPS?

[wed3k]

always recommended.

[theSOB]

ok thanks. will do