If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
my cb7 dome only has 2 wires on the connector... im confused again.
wired up like this the center dome will turn on. and the switches work. but only when a door is open.
what should i hook up the white/blue wire to get power from? since i think thats my problem. in the picture its together with the red wire and i just stuck them into the contacts on the clip. i didnt want to cut any wires yet.
hookup wire
the only place to mount this is here
for my mounting 2 washers 1 bolt and 1 nut
you can see i ground down the sides of the top washer
fit the top washer inside then turn it
wrap some wire around the bolt and sandwich it between the two washers tighten up the nut. feed the wires through the bolt holes and twist them together until map light sits as flush as possible
clip the wires and pop in cover
mines a little ehh but all in all im happy. let me know what you think
Fixed it. double sided tape wasnt enough to hold it on there. I used the washer the same way as before but I put the screw through the wood locked it up with a nut on the end of it, then drilled into the wood using the 2 holes on the legend map light. looks way better and doesn't move around when I push the buttons. Sweet on a side note do I have that oval cut out piece of sheet metal up there because I have an EX (sunroof) ?
I never knew there was an OEM map light. This came on DX, LX, and 10AN models?
FYI - Anyone looking to do this mod
The same map light assembly was also available on the 97-01 CR-V though I am not certain if the 2 mounting screw holes locations were exactly the same.
My guess it is since it would be less expensive than making another part that looked the same but was only slightly different. But of course this is Honda so you never know...
Comment