If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
-welded in manual transmission bracket, pulled motor back out.
Whats left to do
-finish wire tuck on driver's side
-put some seam sealer over the manual bracket
-paint engine bay and grill
-install 4040 valve
-recieve parts from gary
-wire up jdm one pieces again
-get miscellaneous gaskets
Painted the bay
installed 4040 proportioning valve
installed progress rear sway
finished tucking the wires
minimized the power steering system
removed charcoal canister
plan on dropping the motor in when my uncle gets home.
Comment