Hi,
So I narrowed down a parasitic draw on the power lock fuse (#27). It was drawing 12v and when i unplug the power control lock module in the drivers side door all volts go to zero. Does anyone have any experience with this? Should I just replace the module or could the door lock motors be causing this? I tried following this but didn't get too far. Didn't see the point of testing the lock motors when i know they work fine. Been reading for a while on it and some say to just replace the unit.
- All doors lock and unlock just fine.
- Unplugging the switches has no affect
- I'm thinking the relays on the unit are draining the power, but wouldn't this imply that the door locks would not work or would want to stay locked all the time?
Any thoughts?
So I narrowed down a parasitic draw on the power lock fuse (#27). It was drawing 12v and when i unplug the power control lock module in the drivers side door all volts go to zero. Does anyone have any experience with this? Should I just replace the module or could the door lock motors be causing this? I tried following this but didn't get too far. Didn't see the point of testing the lock motors when i know they work fine. Been reading for a while on it and some say to just replace the unit.
- All doors lock and unlock just fine.
- Unplugging the switches has no affect
- I'm thinking the relays on the unit are draining the power, but wouldn't this imply that the door locks would not work or would want to stay locked all the time?
Any thoughts?
Comment