I managed to get a little more done to Lola last night.
I pushed it out of the garage and let it run for about 30 minutes letting all the fluids cycle and see if I have any leaks. After doing this I found a few things that need to be addressed.
- Rear motor mount (Ordered a new one from RockAuto last night. At idle to motor shakes a bit but when revved up a little it goes away. I believe this is because the rubber adjuster is making the mount stiff right now so it shakes at idle. Solenoid is broken on the mount.)
- Radiator cap leaks (Ordering a new one from the Honda dealer today.)
- Fan switch on thermostat housing dead (Will pull the working one off the F22A6 that came out of Lola, and eventually replace the one in the F22A6.)
Will do a few more tests like this and a few other tests before starting to drive it. Will post some pictures of the other progress I made later today.
I pushed it out of the garage and let it run for about 30 minutes letting all the fluids cycle and see if I have any leaks. After doing this I found a few things that need to be addressed.
- Rear motor mount (Ordered a new one from RockAuto last night. At idle to motor shakes a bit but when revved up a little it goes away. I believe this is because the rubber adjuster is making the mount stiff right now so it shakes at idle. Solenoid is broken on the mount.)
- Radiator cap leaks (Ordering a new one from the Honda dealer today.)
- Fan switch on thermostat housing dead (Will pull the working one off the F22A6 that came out of Lola, and eventually replace the one in the F22A6.)
Will do a few more tests like this and a few other tests before starting to drive it. Will post some pictures of the other progress I made later today.
Comment