I recently got my F22 head back from the machine shop, and it is time to properly set valve lash. I have the specs (.009" intake and .011" exhaust), and have even done one round of setting. The problem is that I think I did it wrong
The only way you can turn the cam from the bolt holding on the gear is clockwise, or you will just loosen the bolt. This is what the machine shop told me I should do. It falls into place nicely in 90 degree intervals. I was setting lash in the firing order when going through this process: 1-3-4-2. Since I am rotating it clockwise instead of counterclockwise, should I actually be going through and setting the valve lash in the reverse of the firing order: 1-2-4-3?
Any help or advice is appreciated.
The only way you can turn the cam from the bolt holding on the gear is clockwise, or you will just loosen the bolt. This is what the machine shop told me I should do. It falls into place nicely in 90 degree intervals. I was setting lash in the firing order when going through this process: 1-3-4-2. Since I am rotating it clockwise instead of counterclockwise, should I actually be going through and setting the valve lash in the reverse of the firing order: 1-2-4-3?
Any help or advice is appreciated.
Comment