I am removing my intake manifold to thoroughly clean it. Am going to change out my rear engine mount also and clean injectors. Read more than a few diy's and have had plenum off before. Pretty sure i got all the gaskets and seals i need. 2 for plenum butterfly plate, im gasket itself, o-rings and seals for fuel injectors, rear engine mount without vacuum(westar brand, still made in china).
Throttle body gasket in case i need it. I planned on reusing the egr gasket as it is only a year old and the last one i took off seemed fine itself. I plan on taking a few days to do all this. I have replaced the rear horseshoe coolant hose before but there are a few short ones back there i believe. Maybe i should do these also. Can these be gotten in stainless steel?Any tips greatly appreciated.
Throttle body gasket in case i need it. I planned on reusing the egr gasket as it is only a year old and the last one i took off seemed fine itself. I plan on taking a few days to do all this. I have replaced the rear horseshoe coolant hose before but there are a few short ones back there i believe. Maybe i should do these also. Can these be gotten in stainless steel?Any tips greatly appreciated.
Comment