I have an a6 manual that is going into an a1 auto, but I have to keep the auto trans. I understand I need to use the a6 ecu in order to operate the secondary intake and the proper fuel map, but what do I do about the trans part for the ecu?
Also, which engine harness do I use? I intended to use the a1 due to its additional trans sensors but noticed there's a sensor under the a6's intake on a vaccum box that the a1 doesn't have. What wiring do I need to finish this conversion?
Also, which engine harness do I use? I intended to use the a1 due to its additional trans sensors but noticed there's a sensor under the a6's intake on a vaccum box that the a1 doesn't have. What wiring do I need to finish this conversion?
Comment