Hey, I was just wondering what valve springs are out for a F22B DOHC that would stop valve float reliably. I've seen dual springs for 75 psi of holding force, but I don't know enough to determine if this is adequate.
-
Been a long time. Still alive... -
you're going to have to give an RPM range if you really want an answer. -
Ok, I know I've seen ratings on springs like "UP TO 10,000 RPM!" But I'm not going to run that...
Probably like 8K.Been a long time. Still alive...Comment
-
I know the bisimoto springs are good for at least 7500, prpbably more1990 accord Honda-Challenge, H22 powered
newer race video,older race videos
1991 accord parked, parts and back up shell
1993 accord acquired 6-11-16Comment
-
75lbs should be fine...stock is like 45-55.Comment
-
Neat, I'll probably pick up a set in the near future. Thanks!Been a long time. Still alive...Comment
-
Would stiffer valve springs have any adverse affects at lower rpm's?
H22 Fund Cancelled. Flight training underway.Comment
-
a valve spring will help with wilder camshafts but at low rpms no.Comment
-
Don't forget that the higher seat pressure springs that you use. The faster your valve seats will wear if not machined properly. Make sure you get a valve job done that is specific to your spring pressure and style of driving you intend to put them through. Race/Street Strip/Daily Driver.Comment
Comment