how many c b 7 guys are running it? what parts did you use?
Announcement
Collapse
Please DO NOT Post In The General Section
From this point on until otherwise briefed, posting in the general section of Performance Tech is prohibited. The only thing to remain here will be the stickies. We would just delete this section, but that would cause unintended results.
The majority of the threads created can appropriately be placed in one of the Performance Tech sub-forums or Technical; and the posting of them here is detrimental to the activity of said forums. If you have any questions about where you need to place your thread PM me or one of the other mods.
For the most part you all have caught on without this post, but there have been a few habitual offenders that forced me to say this.
Everyone will get a couple of warnings from here on out, after that I just start deleting threads.
Again if you have any questions, PM me or one of the other mods.
The majority of the threads created can appropriately be placed in one of the Performance Tech sub-forums or Technical; and the posting of them here is detrimental to the activity of said forums. If you have any questions about where you need to place your thread PM me or one of the other mods.
For the most part you all have caught on without this post, but there have been a few habitual offenders that forced me to say this.
Everyone will get a couple of warnings from here on out, after that I just start deleting threads.
Again if you have any questions, PM me or one of the other mods.
See more
See less
water injection
Collapse
X
-
Originally posted by 91accordexr33im looking to run this on my next setup since i dont wanna upgrade my FMIC...I've seen good kits for about 3-400...
Comment
-
if you could use a dsm pump, than you could do an ENTIRE 2 stage kit for under $120.. aquamist charges $500+ for that.. well the diy is going to have to wait because for the next 3 weeks i am going to be in laurel training..Last edited by flacopower; 08-08-2006, 01:45 AM.
Comment
-
this is what my DSM kit is going to consist of and basic prices:
going to tap into stock windshield resovoir (free)
either dsm fuel pump ~$15/ or shurflo 60psi pump $60
high pressure fuel injection hose ~ $15
12v solenoid to keep water from running through lines unless pump on ~ $25
hobbs pressure switch- $25 from napa
2 nozzles for injection ~$8
fittings ~10
clamps, jb weld, & tap- free
relay- $5
led's ~ $5
so around $110 for an adjustable stage 2 setup!
Comment
Comment