5 spd components

[CB7Man]

Hey guys quick question
Is the Type S Clutch components interchangable?
I want to use H22A flywheel
H22A7 Pressure plate
H22A1 stock clutch

I'm just concerned about parts not fitting after I buy them.

[bcjammerx]

Hey guys quick question
Is the Type S Clutch components interchangable?
I want to use H22A flywheel
H22A7 Pressure plate
H22A1 stock clutch

I'm just concerned about parts not fitting after I buy them.

is there a benefit to frankenstein-ing the clutch parts?

[4GAccordH22]

Well, I do know that the F22 and H22 share the same clutch disc and pressure plate, so I don't see why they woujld have something different for the Type S or the A7...

[lucid]

Go for it.
They should all be the same unless they are from an SH.
Use whatever you have and what's in the best condition.

[bcjammerx]

is there a benefit to frankenstein-ing the clutch parts?

still

[lucid]

still

is it really frankensteining if they are actually the same part?

[Night Wolf]

to answer your question, yeah they all should fit.

[bcjammerx]

is it really frankensteining if they are actually the same part?

AH...you have made me smarter

[CB7Man]

Ok another quick question.
I have a Clutch Master Cylinder that has fluid behind it, as in where the shaft pushes into the cylinder.
Does this mean its worn out?
The car drove, atleast it did into a tree.

I mean I want to get a new CMS but if I dont, I would prefer not to
I'm already in my swap for thousands

[lokuputha]

Ok another quick question.
I have a Clutch Master Cylinder that has fluid behind it, as in where the shaft pushes into the cylinder.
Does this mean its worn out?
The car drove, atleast it did into a tree.

I mean I want to get a new CMS but if I dont, I would prefer not to
I'm already in my swap for thousands

the master cylinder is a good thing to replace, especially if you are still using the original. If you see fluid on the shaft, yeah, the seal is worn. You could rebuild your own but getting new seals, its much cheaper.