92 Accord LX with a LT1 350...

[Accrdwgnguy]

That happens.

[deevergote]

A RWD conversion is complicated enough without life getting in the way.

It just sucks that both of our RWD conversions are now dead

[JFISHTHECREATOR]

It's unfortunate that's for sure, he was pretty far along. I hope all is well with him.

PICS :

[Tishock]

That sucks. Hope he's doing ok.

I wish I had the skills to do a rwd swap. I have my friends complete manual g35 in the back yard. With front and rear end damage but all the important parts are still intact.

[BreckAConner]

so he ditched his project?

[Accrdwgnguy]

I'll be honest now and no offense. But I would've junked that car too. Those welds are scary to say the least, just bird shit on and looks like no penetration from here. And thats not good when youre cutting out the frame rails and putting new ones in.

[JFISHTHECREATOR]

I'll be honest now and no offense. But I would've junked that car too. Those welds are scary to say the least, just bird shit on and looks like no penetration from here. And thats not good when youre cutting out the frame rails and putting new ones in.

I agree on the welds not being up to par, however they could have been ground down and re-welded much better. There was rust through some of the paint he put over his welds. It would have not been safe at all IMO if he kept it like that. But what can be fun and safe? lol All jokes aside, a RWD swap is too much work for one person alone on a CB chassis. I give him props for attempting it.

[Straight Success]

It can be done by one man. The three things needed are: money, resources, and time.