So I'm about to drop in my motor. Had the cylinders honed. New rings, rods, bearings, turned crankshaft, oil pump, oil pan gasket, every seal, freeze plugs, all hoses, thermostat, head was totally rebuilt, gates timing belt set, exedy clutch, turned flywheel, and got new axles and deleted power steering and a/c. Is there anything else I should do before I drop the motor in?
-
-
clean engine bayCOUPE K24
-
Lol already did and repainted it the color of the car, I want to do a wire tuck but ill be honest I'd how to hahaComment
-
It is not too bad to do. I did this DIY for the driver side and the passenger side I just cut all the clips and rerouted them in a more subtle way.
http://www.cb7tuner.com/vbb/showthre...ight=wire+tuck
I followed this DIY with great, long, agonizing, traumatizing, success. But it was successful.
So many wires!
Be unique, like every other person.
CB7 Sold________________________E34 Sold________________________E39 Current
Comment
-
Hmmm Idk if I got the patients for that lol my car may end up taking a beating from a hammer before I get done hahaOriginally posted by XCRN View PostIt is not too bad to do. I did this DIY for the driver side and the passenger side I just cut all the clips and rerouted them in a more subtle way.
http://www.cb7tuner.com/vbb/showthre...ight=wire+tuck
I followed this DIY with great, long, agonizing, traumatizing, success. But it was successful.
So many wires!Comment
Comment