F22HB : 1992 Accord EX

[F22HB]

Uh, I have tooooooo
Get the new head disassembled and taken to dg to get surfaced and valves lapped and valve seats ground.
Once that is back assemble the engine.
Buy timing belt/waterpump kit.
Button up the suspension.
Button up the interior.
Decide how far I want/can go with tucking the enginebay. Probly not much.
Make some custom stuff.
Get a trans.
Get the engine back in.
Get the whale penis mounted.
Decide on a header design. Possibly a whole new exhaust setup.
thats just what I can think of right now.

[90ACCORDLXGUY]

Sounds like you have some work ahead of you.

[d112crzy]

Why not just do a valve job instead of just lapping?


Also...I have a few header suggestions that I'd like for you to weld up.

[F22HB]

If you have money to buy the header kits and time to kill helping me mock it up I'm down. I'm getting the valves ground as well as the seats because the head I'm using had bent valves and I just wanna be sure. I could do the valves myself, we have the lathe and the tools, but I don't wanna experiment like that on this engine. But ya, I'm gonna use the valves out of the cracked head and take whichever valve springs test higher.

[F22HB]

Sounds like you have some work ahead of you.

Meh, its enjoyable work. The more the merrier.

[noobcake]

lol at the civic being used as a table btw

[ric3rboi23]

lol at the civic being used as a table btw

it has a table on it too

[d112crzy]

If you have money to buy the header kits and time to kill helping me mock it up I'm down. I'm getting the valves ground as well as the seats because the head I'm using had bent valves and I just wanna be sure. I could do the valves myself, we have the lathe and the tools, but I don't wanna experiment like that on this engine. But ya, I'm gonna use the valves out of the cracked head and take whichever valve springs test higher.

I'll definitely buy the material and will be spending quite some time at your shop

Get on aim you nagger.

[F22HB]

lol I was on aim... kinda. haha I was watchin a movie sorry.

[F22HB]

lol at the civic being used as a table btw

lol its got hella stuff inside it too.

[noobcake]

thats sad

[F22HB]

Measured the bores on the frm sleeves today. They look real good without scoring and measured 87.0077mm +/- a butt hair. This is good news considering I don't want to bother honing the block. I'll be ordering ACL rod bearings as well as some H22 type-s pistons. Should be a thumper.

Bearings
http://cgi.ebay.com/ebaymotors/ACL-R...spagenameZWD1V

Pistons
http://cgi.ebay.com/ebaymotors/_Car-...3A1|240%3A1318

[zack_odom]

OMG...Built motor for u... I=H8zu lol.

[Father Time]

H23 w/ 11:1 comp. Not bad, can't wait to see her finished.

[F22HB]

H23 w/ 11:1 comp. Not bad, can't wait to see her finished.

lol filling it up with premium would suck but I think it deserves it.