OK so i am putting the wagon trunk lid assembly in my coupe and i got a couple questions. I already got all the pieces i need and am about to start cutting what i need.
My first question is about the piece closest to the rear seat that holds the lid. How does this fasten and do i just cut it like a square as the space is 33 inches wide without cutting into the side panels. Do i cut it slightly wide at top so i can notch it into panels.
My second question i think i already know. Where can i remount the abs unit as no way i can leave it there. Or do i need to cut into my drivers side panel? As the side box on drivers side really needs to go in an inch it seems to sit correctly.
Anything or anywhere else i need to cut. I have been thru a lot of these posts but most pics don't work anymore and i see no diy or any pics on ones with abs.
My first question is about the piece closest to the rear seat that holds the lid. How does this fasten and do i just cut it like a square as the space is 33 inches wide without cutting into the side panels. Do i cut it slightly wide at top so i can notch it into panels.
My second question i think i already know. Where can i remount the abs unit as no way i can leave it there. Or do i need to cut into my drivers side panel? As the side box on drivers side really needs to go in an inch it seems to sit correctly.
Anything or anywhere else i need to cut. I have been thru a lot of these posts but most pics don't work anymore and i see no diy or any pics on ones with abs.
Comment