DrummerSteve7 : H23 Boost Build

[drummersteve7]

f22 dx belt works perfect...
everything hooked up.
well while waiting on clutch lines...

I tried to start the bitch.
no joy....fuck!

tried with p06 h23 basemap.
tried with pt3 ecu.

hard to check spark by yourself..but i got spark!
but here it goes..then its breaktime

[d112crzy]

check for fuel.

[drummersteve7]

haha you read my mind i just did...injectors are spraying, can it be my dizzy?
its a brand new dizzy from distributor king

[drummersteve7]

Cel

well I did the cel thing just to make sure...
here is what I got:
6 ECT - water temperature sensor
7 TPS - throttle position sensor
10 IAT - intake air temperature sensor
14 IAC (EACV) - idle air control valve
15 Ignition output signal
20 Electrical load detector

[WiKKeDV16]

HOW I HATE ELD...errrghhhh..

Tps and cel 15 are probably causing the no start..

Iacv = can be disabled in crome until u figure out what's wrong with that.IAT replace it..stupid sensor..

Once again..I HATE ELD PROBLEMS..

[drpnswap23]

well thanx dean, for coming over...
fucking clutchline sucks...

I will get it done tomorrow.
Hopefully ready for a ride friday night!

I like this side pic better!


soon my friends...soon!

Looking forward to it

[d112crzy]

Holy shit, no wonder it's not starting.

Make sure all your sensors are plugged in properly. If they are, then it's time to get a stock harness and undo the wire tuck. You probably fucked up somewhere.

The ELD is the 3 wire thingamajig in the fuse box.

[WiKKeDV16]

Right but even if it is plugged in correctly the ELD gets triggered because something is wrong with the wiring somewhere..shitty situation..

[drummersteve7]

aight man, I just dug through. one of the black wires got caught in the engine on installation of the h23.

Ground fixed...now just errors
7 - throttle position sensor...

need to go get a tps sensor then calibrate it.

brb!

[acc0rd_adicti0n]

good luck it looks to be a nice build

[quickangel93]

U check if u put the gears on the marks? Also check if timing is off. If u got spark, maybe check fuel psi then compression

[quickangel93]

aight man, I just dug through. one of the black wires got caught in the engine on installation of the h23.

Ground fixed...now just errors
7 - throttle position sensor...

need to go get a tps sensor then calibrate it.

brb!

That's good u found ur problem. I rewrapped my wiring and then It didn't start. Wiring is the biggest bitch when it coming to electrical problems

[drummersteve7]

well you can not just buy a TPS...son of a bitch, you need the whole TB.

damn I wish I had one chillin...
anyone got an F or h TPS they wanna give up?

lemme know!

[jDmacCordh22a]

Check xenocron under electronics, omni makes an aftermarket tps for like $49, its listed as b-series but they interchange.

[quickangel93]

well you can not just buy a TPS...son of a bitch, you need the whole TB.

damn I wish I had one chillin...
anyone got an F or h TPS they wanna give up?

lemme know!

yea i think i got one laying around, ill check