Announcement

Collapse
No announcement yet.

Boost_Lee : 1991 Accord EX

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    well, replaced the O ring with an OEM one and some sealant, hoping for no leaks...

    also hooked up the exhaust tonight, will replace the muffler in the rear tomorrow; granted, there are no more leaks or issues....#3inch turboback to a Dynomax muffler shoudl sound.....interesting

    wish me luck


    Formerly 91AccordExR33
    11.68 @ 127mph
    417whp/375wtq
    Sold: 8/2016

    Comment


      Of course....more water leaks....

      THINK i finally found it after dropping coolant 4 times today....gawd i hate coolant. It was the upper small hose on teh back of the intake manifold. Ended up using regular hose clamps, tightened to hell. I think the leak is stopped, we'll see if any accumulates after the next few days



      evildemon - i could not get your map to idle the car what-so-ever! i uploaded my old map and the car idled fine, just rich. Whenever I upload yours, the car idles up and down in consistantly and runs very lean. I dunno what it is...i'll have to examine the maps more closely tomorrow. I even tried to upload your map while the car was running, and it immediately died


      Formerly 91AccordExR33
      11.68 @ 127mph
      417whp/375wtq
      Sold: 8/2016

      Comment


        Originally posted by Boost_Lee View Post
        Of course....more water leaks....

        THINK i finally found it after dropping coolant 4 times today....gawd i hate coolant. It was the upper small hose on teh back of the intake manifold. Ended up using regular hose clamps, tightened to hell. I think the leak is stopped, we'll see if any accumulates after the next few days



        evildemon - i could not get your map to idle the car what-so-ever! i uploaded my old map and the car idled fine, just rich. Whenever I upload yours, the car idles up and down in consistantly and runs very lean. I dunno what it is...i'll have to examine the maps more closely tomorrow. I even tried to upload your map while the car was running, and it immediately died
        Hmmm It shouldn't do that.
        Let me think about it, and I'll look over my maps. PM me what you have changed on my map and I'll sort it tomorrow


        Car Safety / General Servicing Checks --------Basic suspension checks

        My 5.7 LS1 Holden Ute

        A "Finished" project car is never finished until its been sold.

        If at first you don't succeed, Try again. Don't give up too easily, persistance pays off in the end.

        Comment


          Originally posted by evil_demon_01 View Post
          Hmmm It shouldn't do that.
          Let me think about it, and I'll look over my maps. PM me what you have changed on my map and I'll sort it tomorrow
          Whats your climate like(temp, humidity, altitude..etc).

          You guys have the same injectors?

          I wish I had a license for Hondata so I could look at and modify the files.

          CrzyTuning now offering port services

          Comment


            Time to torrent up some hondata lol.

            The New-ish Ride
            My old Ride
            Hear my Vtak!!!
            MK3 Member #3
            I piss off people for fun.
            IA 08 Sunburn Victim #1

            Comment


              Originally posted by d112crzy View Post
              Whats your climate like(temp, humidity, altitude..etc).

              You guys have the same injectors?

              I wish I had a license for Hondata so I could look at and modify the files.
              Go to hondata and download the software for s300 - You can still use it, you just need the license to use the hardware in the ecu.

              Different injectors, but All he has to do is change the "new injector size" in hondata to suit.
              Climates are totally different I would Imagine.
              Average temps 20 degrees Celcius
              Pretty much humidity average 70%
              And altitude conditions - I drive from sea level to 200m


              Car Safety / General Servicing Checks --------Basic suspension checks

              My 5.7 LS1 Holden Ute

              A "Finished" project car is never finished until its been sold.

              If at first you don't succeed, Try again. Don't give up too easily, persistance pays off in the end.

              Comment


                Cool. Good thing texas is just about sea level. But we dont have as much humidity often.

                The New-ish Ride
                My old Ride
                Hear my Vtak!!!
                MK3 Member #3
                I piss off people for fun.
                IA 08 Sunburn Victim #1

                Comment


                  im going to compare everything on the maps tonight and hit u back up. I'll try to make all parameters match, and leave the maps the same. I do notice that you have a bit more timing at idle, my current map is at 16deg in the idle range

                  this is what i had in the notes...
                  9/4/08 - map is tuned for 98 octane = Pulled timing down
                  - Used motec 3 bar, 1000cc, and altered boost cut
                  - Richened fuel from 4K-8K/4psi-12psi by 2 clicks


                  Formerly 91AccordExR33
                  11.68 @ 127mph
                  417whp/375wtq
                  Sold: 8/2016

                  Comment


                    on another note....my filter came in. Man space is VERY tight under the alternator, so I had to get a special filer from K&N



                    they got everything
                    Last edited by Boost_Lee; 09-12-2008, 12:36 AM.


                    Formerly 91AccordExR33
                    11.68 @ 127mph
                    417whp/375wtq
                    Sold: 8/2016

                    Comment


                      holly shit that filter looks like something i need, there is no room in my setup under the alternator, im using a mesh for now \=
                      1991 Accord LX Coupe - Boosted F22 - 5spd LSD - Shaved Bay - Work VSXX - Recaro SRD

                      Member's Ride Page | Video of my CB7, Open Downpipe peelout

                      Comment


                        i hear mesh is not good, and it cuts the surface area. but worse case, tune it will no mesh or screen till you can run a filter.


                        Formerly 91AccordExR33
                        11.68 @ 127mph
                        417whp/375wtq
                        Sold: 8/2016

                        Comment


                          hopefully i can get the car inspected by Friday


                          Formerly 91AccordExR33
                          11.68 @ 127mph
                          417whp/375wtq
                          Sold: 8/2016

                          Comment


                            very bad picture from my phone...



                            but shes on the road again, somewhat


                            Formerly 91AccordExR33
                            11.68 @ 127mph
                            417whp/375wtq
                            Sold: 8/2016

                            Comment


                              WWOOOOOTTTTT!!!!!! this is the first time in prolly three years both of our cars were on the road at the same time!!!! we are winning finally!


                              get vids beeotch!!!! and where the fuck u been mister?



                              (no homo?)

                              "Tucking tires and wires."
                              The Chronicles.

                              Comment


                                hah been busywith tons of things. Not only my car to work on, still helping out on the sti.

                                Tomorrow, i gotta help install Evo springs, do a valve adjustment, and hopefully clean the car up a tad.


                                Formerly 91AccordExR33
                                11.68 @ 127mph
                                417whp/375wtq
                                Sold: 8/2016

                                Comment

                                Working...
                                X