If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
wats the point of the foot bars in the rear, isnt that in the way when ppl sit in the back
The floor bar ties the sides of the chassis to the center section where the propeller driveshaft tunnel is. Prevents any flexing from that general area under hard cornering. As gage said below...its for MID-chassis support/rigidity.
Just a couple more parts that have shown up recently. i have LOTS to do now that the holidays are over.
My new intercooler to replace the stock one. PHOTO of PRE-POLISHING!
sneak peak- lol ive hand polished the top a bit and one of the tubes on the front. you can see how much its gonna take to clean/polish this up.
My list of stuff to finish this weekend:
Beatrush front lower bar install
Beatrush front control arm support bars install
Finish polishing up the intercooler & install IF i finish
Wire up my STRI gauges
Cusco rear trunk bar install
RE-install my Beatrush underpanel ( had to take off for the clutch install)
Couple more parts in transit and ill have pics of those after arrival.
Comment