Michigan Members

[Status Quo]

I think i have started a little trend....i bought a new CB, Cisco's family may obtain a new CB and scott was recently lookin at a new CB!
Whos next!

actually I am! lol

I am looking for a early 90's ex.

I plan on selling/giving my 93 lx to my sister when she gets her licence, so i can stop driving her around and hopefully by then i will have found one. My current Honda isn't a terrible car, but i'm finding more and more its not worth investing to much in.

[Status Quo]

New Recruit?!

So I was picking up a pizza at Little Caesars on Chicago Drive and I spotted an incredibly clean early 90's frost white sedan with a nice little cat back. So, I figured out who owned it and the kid seems fairly nice. Tried to buy it from, but hes not budging. anywho, I figured Kevin and I, and perhaps anyone else who lives in town might want to go get some pizza and try to convince him to get online!

anybody in?

[HondaFan81]

Tell the new recruit about the meet, give him the info and hopefully he'll be there.

Cool, our little family might grow some. Honestly, I'm not about quantity but quality. Too many people can be a pain and more likely to run into some not so cool people.

[HondaFan81]

actually I am! lol

I am looking for a early 90's ex.

I plan on selling/giving my 93 lx to my sister when she gets her licence, so i can stop driving her around and hopefully by then i will have found one. My current Honda isn't a terrible car, but i'm finding more and more its not worth investing to much in.

I purposely bought CB7s without ABS because if it does not work properly or components go bad, they are ALL expensive. Heck both of mine have P/S and A/C removed. More room to work on them and less that goes bad.

My DD 91 DX coupe MT is basic and very reliable, that's what I've filtered it down to. Saves money in the long run, cheap to insure and fix.

[CB7 Sleeper]

So I was picking up a pizza at Little Caesars on Chicago Drive and I spotted an incredibly clean early 90's frost white sedan with a nice little cat back. So, I figured out who owned it and the kid seems fairly nice. Tried to buy it from, but hes not budging. anywho, I figured Kevin and I, and perhaps anyone else who lives in town might want to go get some pizza and try to convince him to get online!

anybody in?

Mark, call me ASAP! I have this nasty itch to wrench on a CB7 and I wanna check your roof rack out. Today is my day off so we can hit up the new recruit as well.

[Status Quo]

Mark, call me ASAP! I have this nasty itch to wrench on a CB7 and I wanna check your roof rack out. Today is my day off so we can hit up the new recruit as well.

Sorry dude I had rehearsal and what not and didn't even get your message until late!

[HondaFan81]

So my dad and I checked out this cappucino brown 91 Accord EX coupe automatic today, has 138,XXX miles. Body was not bad at all for this area, way better than my DD. All electronics work, all suspension joints are OK, new tires, all lights work and has new distributor assembly. However, all shocks need replacement, rear drums need attention, front sway bar end-links need replacement, wiper blades and new alternator. Battery light came on, staying on, when we were on way back to owner's house. Luckily, we made it before it died. It shows the battery is good! So my dad is going to get for mother winter DD use. Keep the 2001 Odyssey off winter roads they have.

[CB7 Sleeper]

Mark, that's too bad man. I don't know when my next day off will be so... We will see. Lol

[HondaFan81]

Kevin's old engine/tranny will be ready to pull this weekend!

With all that removed, I'll prepare engine bay with better condition poly-filled engine mounts, new fuel filter, etc. Then, have to connect newer engine to tranny and bolt it down. At that point I'll repair the suspension and wrap everything up (easier said, than done, many small things involved). Finally, fill everything with fluids, prime motor, set idle and ignition timing.

I'll run this baby for 20 miles, drain the ATF and motor oil, refill with new. Then, it's ready for wheel alignment. After that test drive, see how this F20A DOHC feels in comparison with the F22AX SOHC.

[CB7 Sleeper]

Kevin's old engine/tranny will be ready to pull this weekend!

With all that removed, I'll prepare engine bay with better condition poly-filled engine mounts, new fuel filter, etc. Then, have to connect newer engine to tranny and bolt it down. At that point I'll repair the suspension and wrap everything up (easier said, than done, many small things involved). Finally, fill everything with fluids, prime motor, set idle and ignition timing.

I'll run this baby for 20 miles, drain the ATF and motor oil, refill with new. Then, it's ready for wheel alignment. After that test drive, see how this F20A DOHC feels in comparison with the F22AX SOHC.

Me and my buddy Doug with the pickup truck are taking Sunday, the 25th off. Just hoping it will be done by then and we can swing by and grab it. No worries if it isn't ready though Cisco, because if it isn't done we might just take a little trip to the Casino for a good 'ol time.

[CB7 Sleeper]

I'll run this baby for 20 miles, drain the ATF and motor oil, refill with new. Then, it's ready for wheel alignment. After that test drive, see how this F20A DOHC feels in comparison with the F22AX SOHC.

Cisco made a mistake!

Haha ha, I just noticed it and had to point it out. Cisco, are you telling me my F22AX is a DOHC?!

I had to tease bud.

[nate'sCB7]

Wow you big meany!
JK

[nate'sCB7]

So for the first time scott and i changed the rocker o-rings on his CB. At first we were hesitant cuz we had never done it before and didnt know what we were getting into but it turned out to be Way easier than what we thought.

So yay for us for tackling something that we've never done before!
And getting it right

[CB7 Sleeper]

So for the first time scott and i changed the rocker o-rings on his CB. At first we were hesitant cuz we had never done it before and didnt know what we were getting into but it turned out to be Way easier than what we thought.

So yay for us for tackling something that we've never done before!
And getting it right

Good work!

[nate'sCB7]

Good work!

Yeah,
Such a proud moment!