Originally posted by F20A CB7
Announcement
Collapse
Please DO NOT Post In The General Section
From this point on until otherwise briefed, posting in the general section of Performance Tech is prohibited. The only thing to remain here will be the stickies. We would just delete this section, but that would cause unintended results.
The majority of the threads created can appropriately be placed in one of the Performance Tech sub-forums or Technical; and the posting of them here is detrimental to the activity of said forums. If you have any questions about where you need to place your thread PM me or one of the other mods.
For the most part you all have caught on without this post, but there have been a few habitual offenders that forced me to say this.
Everyone will get a couple of warnings from here on out, after that I just start deleting threads.
Again if you have any questions, PM me or one of the other mods.
The majority of the threads created can appropriately be placed in one of the Performance Tech sub-forums or Technical; and the posting of them here is detrimental to the activity of said forums. If you have any questions about where you need to place your thread PM me or one of the other mods.
For the most part you all have caught on without this post, but there have been a few habitual offenders that forced me to say this.
Everyone will get a couple of warnings from here on out, after that I just start deleting threads.
Again if you have any questions, PM me or one of the other mods.
See more
See less
Top 20 most powerful turbo setups on the board
Collapse
X
-
Last edited by mozzandherb; 11-06-2007, 03:25 PM.
-
Originally posted by mozzandherbIs that what you did?wat
Comment
-
Well, it's good but it's bad. I scored a bearing decently. I'm gonna pull the crank, have that journal polished and go at it again. We never even finished tuning the timing, we just had the fuel straight and was going to start advancing timing and go from there.
This was also through the cat and muffler, full street trim.
The new motor is doing great though, making power past 7000rpm (On delta 260;s)
Updated numbers to come soon. L8rTurbo H23a3 build has begun01-01-2019
Comment
Comment