If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Nic was right, you can't install extended studs without removing the hub from the knuckle. If you leave it on there, they hit the knuckle when trying to put them in from the back. I'm in the middle of it right now, so wish me luck on not screwing up the hub.
EDIT: Screw this, I'm going to do it next weekend.
Installed the progress rear sway yesterday and all i have to say is
slide hammer bolted to the oem lug studs? i've seen that done before. you dont have to take the hub apart. just pull the wheel bearing/ hub out as an assembly. then they will fit.
slide hammer bolted to the oem lug studs? i've seen that done before. you dont have to take the hub apart. just pull the wheel bearing/ hub out as an assembly. then they will fit.
Yeah, I know I can do it without pressing out the hub. I didn't have a 36mm socket to take out the staked axle nut and I didn't feel like running out to the store.
I'll do it sometime in the next month or so. Not going to rush anything, especially after all the problems I've had so far when rushing stuff.
Ummm, it's still the same point it was when I started.... NOWHERE! This weekend Anthony has been kind enough to let me come over and do some work, so hopefully I'll be able to get at least some work done on it. I can't do any cutting where I stay, so I'll have to try and get all of that done at his place and just leave putting it back together until I'm back at my place.
Also, just got these pics from Nic (90Cb7sleeper) (Thanks again man )
Maple50175 - you're annoying =P
Brandoncb7 - I don't mean to come across like an ass but I see why you irritate Aaron now.
JoshM - Crotch rocket = chick magnet.
Those ITRs are gonna look so sweet on your car man! I can't wait to see them on there.
Is the still completely stripped, or did you put the interior back in?
Yeah, I can't wait to put them on. Hopefully they won't look too small.
The car was only stripped for a short time. I loved it while it was though, but it's not practical at all when you have only one car and have to transport stuff and people occasionally.
Comment