F22a1 doesnt come with a spacer...
Announcement
Collapse
No announcement yet.
ENG: diy plenum spacer
Collapse
X
-
Originally posted by PR CB7 View Postwell guys for those who want to get the most out of their intake, i also wanted to so i went ahead and did the double spacer, and found out its pretty easy upgrade.i tried to do this as easy as possible (using all onda parts)
tools needed:
1 12mm socket
2 3 cb7 compressor bolts
3 2 90' prelude compressor bolts
4 2 exhaust nuts
5 jb weld
6 sand paper
7 h22, h23, f22a6, f22b, spacer
first step: get a the spacer, remove butterflies, vaccum diaphram, rod that goes through, and fill in with JB WELD
second step: sand the JB weld till the holes are smooth
third step: take two exhaust nuts and screw them in the bolts in the lower manifold, and take both bolts out
fourth step: put the spacer first, butterfly spacer next and finish with the upper plenum, insert the prelude bolts first to align everything, and then the accord ones
fifth step: tighten everything and smile (some hoses u'll have to change, i didnt)
back view
front view
was this manifold sandblasted?"Self Renewed"
Comment
-
Originally posted by sleepygreen View PostI have a a1 plenum what spacer do i get?
Originally posted by sleepygreen View Postwhich one would fit?
If you have an A1, you are going to have to upgrade to a H23 or A6 intake manifold that has dual runners because the A1s and A4s are both single runners. And no vehicle came with a single runner spacer nor does any company make a single runner spacer.
Hope that clears things up for ya.
Comment
-
Originally posted by PR CB7 View PostMR FRUIT is right
only
prelude b20
accord f22a6
prelude h23
prelude h22
accord f20b
came with the spacer
The H22 Sleeper Sedan, updated 8/14
After 4 months down...It's back! and tucked.
Need a Swap or some work done in the DC/MD/VA/WV area?
PM me and get it done right!
Comment
-
Originally posted by PR CB7 View PostMR FRUIT is right
only
prelude b20
accord f22a6
prelude h23
prelude h22
accord f20b
came with the spacer
Comment
-
Originally posted by PR CB7 View Postwhy u say that
Comment
-
is there a diy on how to remove the IM??DELTA CAM GROUP BUY
http://www.youtube.com/watch?v=PSbCQuhAnNcla gringa pt.1
http://www.youtube.com/watch?v=hMz-F2saG_ola gringa pt.2
Comment
-
Originally posted by MclovinRR View Postis there a diy on how to remove the IM??
Undo like 7-9 nuts (can't remember), pull off a couple of vacuum lines, coolant lines, and that's about it. A Haynes, Chilton, or other repair manual would be helpful.
Maybe when I do my intake mani in then next few weeks, I'll snap some photos and throw a DIY on how to remove and install one. No promises though...
Comment
Comment